Daily Maintenance Of Soft Ice Cream Machine

- Apr 04, 2018-

The cleaning of refrigeration cylinder.

To ensure the health of ice cream consumers and improve the service life of machine parts, you must clean the refrigerating tank once a day.

(1) press the cleaning button to discharge all the slurry in the cylinder and press the stop button.

(2) add the disinfectant with warm water, pour it into the bucket, and the two buckets have the same amount of water.

(3) press the cleaning button to stir for about 1-2 minutes, and discharge the cleaning fluid.

(4) wash with clean water 2-3 times and stop.

(5) turn off the power and dismantle the parts.

A. Screw out four screws on the side of the liquid valve and remove the liquid valve assembly.

B. Take out the pin of the handle, the handle, the stem, and the sealing ring from the outlet valve in turn.

C. Remove the mixer from the refrigeration cylinder and remove the sealing ring.

D. Clean all the parts removed. Please replace them if there is any damage.

E. Assemble the parts according to the reverse procedure.

Fuselage cleaning

Consumers need is beautiful, clean machine, please feel free to keep the body appearance clean, you can use warm towel polishing the dry body, remove dirt and stains, do not wash with water, in order to avoid electrical failure.

Clean the condenser.

Work for a period of time sticky dust affects the cooling condenser, refrigeration effect is poor, cleaning the specific time depending on the operating environment may be three months to half a year, to turn off the power before cleaning, make sure not to damage the condenser fin, with a soft brush and hair dryer can be cleaned up.

Drive to adjust

Machine with long time, after mixing system drive belt may be stretched, need to be adjusted, the phenomenon is the belt creep, the machine suddenly stop after running for a while, the meeting on some soft ice cream machine, digital tube display the words "NL", at the same time a buzzer thrum rule continuously for a long time, at this time to power off, remove the machine on the left side of the panel, using a wrench to adjust the fixed screws at the bottom of the motor (specific circumstances for slight differences, different machine type please dial telephone after-sales consulting) met this is not the machine malfunction, must adjust the belt before the power outage, belt machine back to normal after adjusting the consistence.